I was contacted by a customer in Battersea who was concerned about the state of their Ceramic Tiled shower cubicle. Ceramic tiles are glazed so usually very easy to keep clean however grout has a rough surface and attracts dirt easily. Where this happens it best to keep on top of the problem with regular cleaning as once you get a deep-seated stain on grout it’s very difficult to get it clean again.
The photograph below shows the worst of the problem where dirt had collected behind a wire basket that was fixed to the wall. The basket allowed dirt to build-up behind it and had deposited rust on the tile and grout.
Maintaining grout is a large part of the work Tile Doctor does and we have several tried and tested products and processes for doing this. Having spoken to the client over the phone and having been sent photographs via email I created a quote for the work which should only take a few hours. My customer was happy with the quote and we agreed a date to do the work.
Cleaning a Ceramic Tiled Shower Cubicle
To begin, I cleaned the grout lines using our acidic cleaning product, Tile Doctor Grout Clean-Up. The product is decanted into a spray bottle and sprayed onto the tile and grout where it was left to dwell for ten minutes before being scrubbed in with a handheld scrubbing brush. Spraying the solution onto the wall mixes it with air to make it lighter and more able to stick to the wall.
Being a concentrated phosphoric acid cleaner, Grout Clean-Up effectively removes mineral deposits including rust and old grout smears from the tile surface to leaving it looking much fresher, it also prepares the grout for a superior bond with the grout colourant that was to be added later.
Following this, I rinsed down the tile and grout with water to remove the dislodged dirt. The next step was to remove all the existing silicone mastic with a sharp knife; the mastic sealant stained with mould and much in need of replacement. Once all the rubbish was swept out, I dried any remaining dampness from the grout and tiles with a heat gun.
I then moved onto to recolouring the grout using a Tile Doctor Grout Colourant which is simply painted onto the grout lines using a small brush and any excess wiped of the tile before it dries. There are eleven colours available in the Tile Doctor colourant range and in this case, we chose a colour to match the tiles.
The application of Grout Colourant not only colours the grout joints – it also seals the grout in so dirt can’t become stuck in its rough surface, this also makes it very easy to clean going forward.
Once the restoration was finished, I resealed the shower base with fresh mould resistant silicone mastic to match the tile and grout. Tile Doctor don’t sell this but there are many makes available from local DIY stores.